X-Pro3 · XF50mmF1.0 R WR

Every part,in its place.

A rangefinder and a 50 mm f/1.0, drawn in thirty-seven parts and one line. Scroll, and it comes apart. Click any part to take a closer look.

02 — Apart

Thirty-sevenparts.

Each one leaves along the line it goes in by: from behind, from below, from above, from the front.

03 — Sensor

17.7 mm behindthe mount.

A back-illuminated sensor, a focal-plane shutter in front of it, and the board that reads it, layered into the back of the body.

04 — Dials

Read it withthe camera off.

Shutter speed and ISO share one dial. Exposure compensation sits on the corner, where the thumb already is.

05 — Finder

A window anda screen, in one.

Look through glass, or through a 3.69-million-dot OLED. A lever on the front switches between them.

06 — Lens

f/1.0.

Twelve elements in nine groups, and nine rounded blades. Keep scrolling: they close the light down, and open it again.

07 — Mount

A twist,and it locks.

Three bayonet lugs, ten contacts and four screws. The lens goes on, turns, and the hood follows it.

08 — Built

Builtagain.

Thirty-seven parts, back where they belong. 1,342 g with the lens.

Specifications

Figures from the published specifications. The drawing's internal parts are sized from photographs: close, not exact.

Body

SensorAPS-C X-Trans CMOS 4, back-illuminated
Resolution26.1 MP
Sensor size23.5 × 15.6 mm
Viewfinder0.52× optical, 3.69M-dot OLED
Rear screen3.0″, flips down
Cards2 × SD
PlatesTitanium, top and bottom
Weight497 g with battery

Lens

Focal length50 mm (76 mm equiv.)
Aperturef/1.0, 9 rounded blades
Construction12 elements in 9 groups
Special elements1 aspherical, 2 ED
Filter⌀ 77 mm
MountX mount, 17.7 mm flange
Size⌀ 87 × 103.5 mm
Weight845 g